Yamaha RX-V365 Bedienungsanleitung Seite 43

Problem
Only the center When playing a monaural source with a
speaker outputs
CINEMA DSP program, the source signal
substantial sound. is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard "CENTER" in "SPEAKER SET" is set to
from the center
"NONE."
speaker.
Some sound field programs do not output
sounds from the center speaker.
No sound is heard "SUR. LR" in "SPEAKER SET" is set to
from the surround "NONE."
speakers.
This unit is in the "STRAIGHT" mode
and a monaural source is being played
back.
No sound is heard "BASS OUT" in "SPEAKER SET" is set
from the subwoofer. to "FRONT" when a Dolby Digital or
DTS signal is being played.
"BASS OUT" in "SPEAKER SET" is set
to "SWFR" or "FRONT" when a 2-
channel source is being played.
The source does not contain low-
frequency bass signals.
Dolby Digital or DTS The connected component is not set to
sources cannot be
output Dolby Digital or DTS digital
played. (Dolby Digital signals.
or DTS indicator on
Audio input jack select is set to
the front panel
"ANALOG."
display does not light
up.)
A humming sound is Incorrect cable connections.
heard.
The volume level You are attempting to set the volume level
cannot be increased, higher than the maximum volume level.
or the sound is
The component connected to the AUDIO
distorted.
OUT (REC) jack on this unit is turned off.
The sound effect
It is not possible to record the sound effect
cannot be recorded. with a recording component.
A source cannot be The source component is not connected to
recorded by an
the analog AUDIO IN jacks on this unit.
analog component
connected to the
AUDIO OUT (REC)
jack.
The sound field
"MEM.GUARD" in "OPTION MENU" is
parameters and some set to "ON."
other settings of this
unit cannot be
changed.
Cause
Set "CENTER" to "SML" or "LRG."
Try another sound field program.
Set "SUR. LR" to "SML" or "LRG."
Press M STRAIGHT on the front panel so that
"STRAIGHT" disappears from the front panel
display.
Set "BASS OUT" to "SWFR" or "BOTH."
Set "BASS OUT" to "BOTH."
Make an appropriate setting following the operating
instructions for your component.
Set Audio input jack select to "AUTO."
Connect the audio cables firmly. If the problem
persists, the cables may be defective.
Adjust "MAX VOL." setting.
Turn on the power of the component.
Connect the source component to the analog AUDIO
IN jacks.
Set "MEM.GUARD" to "OFF."
Troubleshooting
Remedy
See
page
32
25
32
26
32
32
—
19
—
34
—
13
35
39
En