Yamaha RX-V365 Bedienungsanleitung Seite 45

Problem
The desired station
cannot be tuned into
with the automatic
tuning method.
AM There are continuous
crackling and hissing
noises.
There are buzzing and
whining noises.
■
AUTO SETUP
Before AUTO SETUP
Error message
Connect MIC!
Optimizer microphone is not connected.
Unplug HP!
Headphones are connected.
During AUTO SETUP
Error message
NO FRONT L SP
Front L/R channel signals are not detected.
NO FRONT R SP
NO SUR.L SP
A surround channel signal is not detected.
NO SUR.R SP
NOISY
Background noise is too loud.
NO MIC
The optimizer microphone was unplugged
during the "AUTO SETUP" procedure.
USER CANCEL
The "AUTO SETUP" procedure was
cancelled due to user activity.
Cause
The signal is weak or the antenna
connections are loose.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
A TV set is being used nearby.
Cause
Cause
Remedy
Tighten the AM loop antenna connections and
orient it for the best reception.
Use the manual tuning method.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV set.
Remedy
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Remedy
Check the front L/R speaker connections.
Check the surround speaker connections.
Try running "AUTO SETUP" in a quiet environment.
Turn off noisy electric equipment like air conditioners
or move them away from the optimizer microphone.
Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the front panel.
Run "AUTO SETUP" again.
Troubleshooting
See
page
—
27
—
—
See
page
16
—
See
page
9
9
—
—
16
16
41
En