Changing The Battery; Initial Use - LIVARNOLUX KH 4246 Bedienungsanleitung

Placement
For best results, place your Solar lamp in a
location where sunlight shines directly onto the
collector panel 4. Direct sunlight of at least 8
hours is ideal to ensure that the battery is fully
charged. The location must be free from shadow
and shade. Make sure that the collector panel
4 is not subjected to light sources other than
sunlight. Otherwise, the lamp will not be swit-
ched on at twilight.

Initial use

Remove the collector panel 4 together with
the reflector 5 out of the housing 6.
Turn the reflector 5 somewhat against the col-
lector panel 4, until it releases itself from the re-
straint.
Remove the reflector 5 from the collector pa-
nel 4.
Place the function switch 1, on the bottom of
the collector panel 4, at the ON position.
Place the reflector 5 and the collector panel
4 back together again.
Replace the collector panel 4, together with
the reflector 5, back into the housing 6.
Place the solar lamp at a suitable location.
Note:
The charging process will only start if the functi-
on switch 1 is in the ON position. It can take a
few days until the Solar Lamp has reached its
optimal performance efficiency.
After the battery is charged, the solar light turns
itself on automatically at dusk.
To switch the solar lamp off, place the functi-
on switch 1, on the bottom of the collector
panel 4, into the OFF position.

Changing the battery

Replace the battery when the illumination time,
despite a day-long charge period, diminishes af-
ter 2 hours of darkness.
Remove the collector panel 4 together with
the reflector 5 out of the housing 6.
Turn the reflector 5 somewhat against the col-
lector panel 4, until it releases itself from the re-
straint.
Remove the reflector 5 from the collector pa-
nel 4.
Open the battery compartment 3 on the un-
derside of the collector panel 4.
Remove the battery and replace it with a new
one of the same type. When inserting it, com-
ply with the polarities.
Close the battery compartment 3 and repla-
ce the reflector 5 and the collector panel 4
back together.
Replace the collector panel 4, together with
the reflector 5, back into the housing 6.
Cleaning
Clean the collector panel 4 with a moist cloth.
Clean the housing 6 of the solar light with a
soft brush.
Attention!
• Do not use aggressive or chemical cleaning
agents. These could cause damage to the
appliance.
- 12 -