Safety Instructions For Rechargeable Batteries; Select A Suitable Place For Installation; Mounting The Light; Initial Use - LIVARNOLUX IAN 88651 Bedienungs- Und Sicherheitshinweise

Safety notes / Assembly / Initial use / Use
dangers. Always keep children away from the
packaging material. This product is not a toy.
Children or persons lacking knowledge or
experience in handling the device or have
limited physical, sensory or mental abilities,
must not use the device without supervision or
instruction by a person responsible for their
safety. Children must be supervised at all times
to prevent them from playing with the device.
CAUTION! DANGER OF INJURY! Please
do not use this device if you find that it is dam-
aged in any way.
Verify all parts are correctly installed. Incorrect
assembly could lead to injury.
Safety instructions for
rechargeable batteries
Rechargeable batteries are not intended to be
in the hands of children. Do not leave batteries
lying around. They may otherwise be swallowed
by children or pets. If accidentally swallowed
seek immediate medical attention.
EXPLOSION HAZARD! Never
short-circuit and/or open rechargea-
ble batteries. The battery may over-
heat, ignite or explode. Never throw recharge-
able batteries into fire or water. The batteries
could explode.
Regularly check rechargeable batteries for leaks.
Skin contact with leaking or damaged
rechargeable batteries could cause chemical
burns; in this case therefore always wear suita-
blesafety gloves!
When inserting the battery ensure the correct
polarity! The correct polarity is shown inside
the battery compartment. The rechargeable
batteries could otherwise explode.
18 GB/MT
DANGER TO LIFE!
Assembly
Select a suitable place
for installation
Ensure that
– the motion detector will not be functionally inhib-
ited at the desired place of installation due to
obstacles or constantly moving objects.
– the motion detector is not installed where there
are strong temperature fluctuations, e.g. due to
heating devices or air conditioners.

Mounting the light

Secure the light to a stable and solid surface
according to the instructions in figures A–C.

Initial use

Note: the rechargeable batteries are always
factory installed.
To achieve a long battery life, fully charge the
rechargeable batteries in OFF mode
(approx. 2 days).
Then fully discharge the rechargeable
batteries, preferably in ON mode.
Repeat this process once or twice.
If the product has not been used for more than
6 months please repeat this process.
Use
The light features three settings (see Figure D):
OFF:
light always off
AUTO: Light always on (ECO mode)
PIR: Motion detector controls the light
In „PIR" the light will switch on if the surround-
ings are very dimly lit and motion is detected
(infrared sensor). The light will automatically
switch off after 90 seconds if motion is no
longer detected.
Attention: a light sensor is located inside the
solar panel. The panel must therefore be
mounted far away from artificial light sources.