GUTMANN Nube Bedienungsanleitung Seite 13

Button 3: Intensive stage (motor switches
automatically back to Stage 3
after 3 min)
Button 4: Light ON / OFF, through longer
pressing lighting can be dimmed.
Battery chamber 5: Please em-
ploy batteries of the Type AA
exclusively
Operation by switches (located on the
Upper tower below the plate)
Pressing the switch to the left: Light ON /
OFF Pressing the switch to the right: Control
of the fan power
Pressing the switch for 3 sec to the right:
Bonnet is switched off.
The filter saturation indication is likewise
reset over this switch. Keep the switch
pressed to the right until the red LED goes
out.
LED display (located on the
Upper tower)
Specifications of the operational state of the
bonnet can be read off on the LED display
of the device:
R u n D o w n
S ta g e 1 :
S ta g e 2 :
S ta g e 3 :
In te n s iv e s ta g e :
F ilte r s a tu r a tio n In d ic a to r :
LED 1: Display ON / OFF operating status
LED 1 flashing: Display automatic delay
switch-off time
(The bonnet switches down a power stage
automatically every 5 min, until the final
disconnection)
:
LED 2: Fan power Stage 1 (low motor power)
Press once Button 2 of the remote control
LED 3: Fan power Stage 2 (medium motor
power)
Press twice Button 2 of the remote control
twice
LED 4: Fan power stage 3 (high motor po
wer)
Press three times Button 2 of the remote
control
LED 5: Intensive stage (motor switches
back to Stage 3 automatically after
3 min)
Press Button 3 of the remote control
LED 6: Filter saturation display
With lighting of the red LED, the metal filters
are to be cleaned (see section on cleaning
and maintenance). The filter saturation
indication lights up 14-active or approx. 15
hours of operation.
en