Ferm JSM1028P Originalbetriebsanleitung Seite 6

Mounting
• S lacken the Allen screws (13) using the Allen
key (11).
• I nsert the saw blade (14) in the saw blade
holder (6) as far as possible. The teeth of
the saw blade (14) must point upward and
forward. The smooth side of the saw blade
must engage in the slot of the guide roller .
• T ighten the Allen screws (13) using the Allen
key (11).
Removing
• S lacken the Allen screws (13) using the Allen
key (11).
• R emove the saw blade (14) from the saw blade
holder (6).
• T ighten the Allen screws (13) using the Allen
key (11).
Saw blade Material
Coarse Wood
Medium Wood
Fine Steel, aluminium, plastic
Very fine Wood (curves)
Do not attempt to remove the guard from
the machine.
USE
The On/Off switch (fig. A)
• S witch the machine on by pressing the On/Off
switch (1). When you release the On/Off switch
(1) the machine will turn off.
• T he rotation-speed can be adjusted by
pressing the On/Off switch (1) harder for
raising the rotation-speed or release pressure
for lowering the rotation-speed.
Lock-on Button
• Y ou can lock the On/Off switch (1) by pressing
the On/Off switch (1) and then pressing the
lock-on button (2).
• T o release the switch-lock; shortly press the
On/Off switch (1) again.
Setting the mitre angle (fig. C)
The mitre angle is variable between -45° and +45°.
6
Do not set the mitre angle during use.
• S lacken the Allen screws (17) using the Allen
key (11).
• T ilt the saw shoe (7) to the required position.
• T ighten the Allen screws (17) using the Allen
key (11).
Using the pendulum action switch (fig. A)
The pendulum action switch is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions.
Do not set the pendulum position during
use.
• T urn the pendulum action switch (2) to required
position according to the material to be
worked. Refer to the table below to select the
required position.
Material Pendulum position
Wood 1-3
Plastics 1
Aluminium 0-1
Steel 0
Ceramics 0
Rubber 0
Dust extraction
• C onnect the hose of a vacuum cleaner to the
dust extraction adapter (9).
Hints for optimum use
• C lamp the workpiece. Use a clamping device
for small workpieces.
• D raw a line to define the direction in which to
guide the saw blade.
• F irmly hold the machine by the grip.
• S et the sawing speed.
• S et the mitre angle.
• S et the pendulum position.
• S witch on the machine.
• W ait until the machine has reached full speed.
• P lace the saw shoe on the workpiece.
• S lowly move the machine along the pre-drawn
line, firmly pressing the saw shoe against the