Setting Up And Connecting The Message Light; Operation; Memorizing Messages - IMG STAGE LINE PML-80R Bedienungsanleitung

1) Remove the cover of the battery compartment on the rear
side of the remote control: Slightly press the spot marked
with an arrow while simultaneously pulling the cover down-
wards.
2) Insert the batteries with the positive and negative connec-
tions as indicated in the compartment.
3) Replace the cover and let it lock into place.

3.2 Setting up and connecting the message light

1) Place the message light as desired or fasten it via the two
supplied self-adhesive pads (e. g. to a window pane). For
this purpose, fasten the two pads which are self-adhesive
on both sides to the feet of the message light and glue the
message light to the desired place. Make sure that the sur-
face where the message light is to be glued on is clean,
smooth, and free from grease.
2) Turn the housing to a position which ensures a good visibil-
ity of the display (1). It can be turned by 360° around it hori-
zontal axis.
3) The message light is connected to the mains via the sup-
plied plug-in power supply unit. Connect the plug (2) of the
cable of the message light to the inline jack of the cable of
the power supply unit. Connect the power supply unit to a
mains socket (230 V~/50 Hz). Thus, the message light is
switched on.

4 Operation

After connection to the power supply, all LEDs of the display
(1) will shortly light up, then the unit is in the mode "BANNER"
(see chapter 4.2.1 "Displaying the BANNER message").
The message light may now be controlled via the remote
control. For this purpose, point the remote control at the front
or rear side of the unit. Each time a key is pressed on the
remote control, the indicating LED (3) will shortly flash (see
chapter 4.4 "Indicating LED on the rear side of the unit").

4.1 Memorizing messages

1) Press the key EDIT (6). The last message displayed before
the key was pressed will appear, followed by the cursor
(small square consisting of 9 LEDs) which flashes to indi-
cate that a new character can be entered here.
2) Delete the message displayed:
either delete character by character with the key
ERASE (8)
or delete the whole message with the key DOWN (10).
After the message has been deleted, only the cursor will
flash on the display.
3) Then enter an individual message or call a preprogrammed
message:
GB
13