Mechanical Mounting; Mounting To Linear Actuators; Preparation Of The Valve Actuator; Assembling The Travel Sensor - Gemü 1436 cPos eco Betriebsanleitung

3

Mechanical mounting

3.1

Mounting to linear actuators

3.1.1

Preparation of the valve actuator

The actuator must be in the zero position
G
(actuator vented).
Should there be an optical position
G
indicator in the actuator (a red spindle), it
must be removed.
3.1.2

Assembling the travel sensor

Pretensioned spring!
® Damage to the device.
Slowly relax spring.
DANGER
Attention:Damage to the spindle
surface may lead to failure of the
travel sensor!
The travel sensor is assembled using a
mounting kit 1436S01Z... (direct mounting)
or 4232S01Z... (remote mounting)
consisting of a spring, an operating bush
and a threaded adapter (if applicable). The
mounting kit depends on the valve type.
Travel sensor
Compression spring
Spindle
Mounting kit
1. Pull out the spindle of the travel sensor up to
the limit stop.
2. Push the spring over the spindle.
3. Fix the spindle at point a
(the spindle must not be damaged
during this process).
a
1436 cPos eco
4. Screw the operating bush onto the spindle.
3.1.3
Operating bush
G
32 / 56

Mounting the positioner

1
2
3
Valve with positioner
Assemble the travel sensor (see chapter
3.1.2 "Assembling the travel sensor").
Mount the positioner 1 by screwing the
travel sensor hexagonal nut SW27 2 into
the actuator 3.
The positioner must not be
fi xed by turning the housing as
this may result in the danger of
overturning the internal stop.