L) Function Control Of Servos - Reely Earth Crusher Pro Bedienungsanleitung

l) Function control of servos

Steering servo
The steering servo is connected to channel 1 of the remote control
transmitter, to the steering wheel.
Structure of steering
The steering of the vehicle is designed as an axle leg steering.
At the same time the steering knuckle arms are connected with the three-
part steering link. The pivoting movement of the servo control lever has
an effect on the steering linkage (1) and on one arm of the servo saver
(2). The servo saver consists of two levers arranged at right angles, which
are not rigidly coupled but which can move against each other via a
spring along the same plane of movement as the servo steering lever.
The second lever arm of the servo saver (3) steers the centre part of the
steering linkage, the steering plate, and in this way causes the wheels to
turn via the steering linkage (4). When hard shocks are carried in via the
steering link during operation, they are not immediately transmitted to
the steering servo, but are absorbed with the help of the resilient
connection of the two lever arms of the servo saver.
Turning right and left is limited by a mechanical stop of the steering knuckle arm against the axle leg support.
Function control
• Support the model at the front in a way that allows the wheels to hang freely.
• Due to the good traction of the wheels and the weight of the vehicle, the wheels would not follow your steering commands spontaneously and directly while the
wheels stand still on the floor. This however changes during operation.
• First switch on the transmitter, then the receiver.
• Move the steering wheel (channel 1) towards the right and the left.
• Now the wheels must turn towards the right and the left!
• If the wheels turn in the opposite direction, switch the servo reverse on the remote control into the "REV" position (reverse).
• Release the steering wheel; now the wheels must return to the straight position. If the wheels do not point exactly forward when the steering wheel is in neutral
position, correct the trimming on channel 1. Turing the steering wheel all the way to the left or the right should also turn the wheels all the way to the left or right!
Servo saver
The servo saver has already been pre-adjusted. Before first use it has to be checked and might have to be set tighter (so that the control commands
of the steering servo are carried out when driving quickly).
Throttle/brake servo
The throttle/brake servo is connected to channel 2 or the remote control transmitter.
39