Remedy Of Faults; Maintenance And Cleaning - Oase BioCompact 50 Gebrauchsanleitung

- EN -
Protective measure: Regularly check the
water level in the aquarium.
 C
•
Fasten the device, e.g. to the wall of the
aquarium.

REMEDY OF FAULTS

Malfunction
The unit does not start up
Water flow insufficient
Insufficient filtering perfor-
mance

MAINTENANCE AND CLEANING

•
If necessary, clean with clear water using a
soft brush.
•
Cleaning and replacement cycles for filter me-
dia such as foam filters or activated carbon
are dependent on the size of the aquarium
and the number of fish. Therefore, it is neces-
sary to clean and replace the filter media as
required to ensure optimum filter perfor-
mance.
16
Cause
No mains voltage
Impeller unit blocked
Regulator closed too far
Filter housing or impeller unit soiled Clean
Impeller unit worn
Foam filter clogged
Foam filter worn
The activated carbon is exhausted.
•
Route the power connection cable such that
it forms a drip loop!
•
Switching on: Connect the unit to the mains.
The unit switches on immediately.
•
Switching off: Disconnect the unit from the
mains.
Remedy
Check the mains voltage.
Clean
Adjust regulator
Replace impeller unit
Clean
Replace
Replace the activated carbon.
Cleaning or replacing the filter media
BioCompact 25
How to proceed:
 A
1. Remove the lid of the filter container.
2. Pull out the foam filter and rinse in warm wa-
ter or replace.
BioCompact 25/50