Place The Drill Holes; Attaching The Exhaust Hood - hanseatic SY-3288B3-P1-C13-L22-600 Gebrauchsanleitung

Page GB-12 Assembly

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
hood must be at least 65 cm for gas
stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
2. Draw the five drill holes on the wall, fol-
lowing the upper diagram. Pay attention
to the hole distance and horizontal orien-
tation of the wall brackets.
3. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
4. Place the dowels into the holes.

Attaching the exhaust hood

(5)
Stifte
1. Place the two halves of the check
valve (5) into the opening on the top of
the exhaust hood (1). Make sure that the
pins on the valve are facing outwards.
(12)
(8)
2. Screw the wall bracket (8) for the exhaust
hood into the dowels using three counter-
sunk screws (12).
3. Hook the exhaust hood onto the wall
bracket (8).
(5)