g) Installing the Nose Gear and Fuselage Nose
Hook the linkage clevis (1) into the inner hole of the steering lever at the nose
gear (2) and secure the clevis by pushing the rubber hull (3) onto it.
Guide the linkage rods into the fuselage and screw the nose gear to the fuselage
with 4 wood screws.
Push the fuselage nose out of the fuselage and align if correctly. Use adhesive
tape to provisionally attach the nose.
Use a small drill to pre-drill two holes in each side and then screw on the hood
with four screws (1).
36
Figure 10a
Figure 10b
Figure 10c