Reely SKY Islander Bedienungsanleitung Seite 35

Attention!
When gluing on the elevator unit, ensure that the steering linkage
(1) is pushed through the linkage guide (2) in the fuselage!
Glue the rudder Bowden cable (3) to the rod guide (2) using 5-minute epoxy
glue.
Also glue the rudder (1) into the provided groove in the upper side of the fuselage
using 5-minute epoxy glue.
Make sure that the rudder is at exactly 90° to the elevator.
Connect the clevis (1) to the rudder horn (2) and secure the clevis by pushing
the rubber hull (3) onto it.
Glue the Bowden cable cap (4) to the cut-out in the fuselage with instant
adhesive.
Ensure that the distance between the Bowden cable cap and the
soldering cap is large enough to enable the required rudder
deflection.
Figure 9d
Figure 9e
Figure 9f
35