Replacing Air Filter - Comprag A9008 Bedienungsanleitung

1
Fig. 5.4.2 Oil filter replacing
Fig. 5.5 Air filter replacing
COMPRAG Screw air compressor A-Series
1
2
Open the left side panel. Remove the oil
filter (1) using a special Oil Filter Wrench.
Drain the oil from the filter into a dedica-
ted vessel and clean the filter seat.
Oil the gasket of the new oil filter and
screw it into place. Only tighten oil filter by
hand.
Start up the compressor.
Stop the compressor and let it run idly
for several minutes in order for the oil to
circulate and air to be extracted from the
oil system. Wait several minutes until the
oil settles and the inner pressure drops.
If necessary, unscrew the fill plug and add
oil until it is level with the middle of the
sight glass.
Place the fill plug into its initial position
and tighten it.
5.5

Replacing air filter

The air filter (1) is attached to the com-
pressor's intake valve.
In order to replace it, open the front side
panel, loosen the clamp (2) securing the
filter. Remove the contaminated filter, and
detach the clamp from it.
Set the new filter in its place and fit into
place with the clamp.
27