Operation; Standby Mode; Setting The Clock; Setting The Timer - Silvercrest SMWC 700 A1 Bedienungsanleitung

Operation

NOTE
► Every press of a button is acknowledged with a beep.

Standby mode

The appliance automatically switches to standby mode and the display
the time if no button is pressed for a long time.

Setting the clock

After plugging in the appliance, the display
♦ Press and hold the timer/clock button
appears on the display
♦ Turn the dial
–
"Hr 24", the clock displays the time in 24-hour mode.
or
–
"Hr 12", the clock displays the time in 12-hour mode.
♦ Confirm your selection by pressing the dial
♦ Turn the dial
selection by pressing the dial
♦ Turn the dial
Confirm your selection by pressing the dial
The time is now set.

Setting the timer

The appliance has a timer that you can use independently of microwave operation.
♦ Press the timer/clock button
This works during standby mode as well as during operation.
:
♦ Set the desired time using the dial
You can set a time from 10 seconds to 95 minutes.
The increments for setting the time are as follows:
–
from 0 sec to 5 min: in 10-second increments
–
from 5 to 10 min: in 30-second increments
–
from 10 to 30 min: in 1-minute increments
–
from 30 to 95 min: in 5-minute increments
SMWC 700 A1
("H":"Hour").
to select the desired mode:
to set the hours. The hour display flashes. Confirm your
to set the minutes. The minute display flashes.
and the symbol appear on the display
shows :
for a few seconds. "12 H"
.
.
.
to activate the timer.
.
.
shows
.
GB │ MT │ 73 ■