Before The First Use; Operation - Silvercrest STK 650 A1 Bedienungsanleitung

Before the First Use

• Remove all packaging materials from the appli-
ance.
• Carefully rinse all parts of the brewing system
(brew chamber 0, water riser pipe q, Sieve w)
and the glass pot 3 (see chapter "Cleaning
and Care").
Proceed as follows before the first usage:
1. Remove the glass pot 3 from the base 5.
2. Fill the glass pot 3 up to the MAX marking with
water, then add a teaspoon of lemon juice (or le-
mon concentrate) to it. If lemon juice is not avai-
lable, you could add a teabag (or a teaspoon of
loose tea) directly into the water.
3. Replace the brew system in the glass pot 3.
4. Close the lid 1 and replace the glass pot 3 on
the base 5.
5. Switch the appliance on with the On/Off switch 8.
The control lamp 4 and the On/Off switch 8
light up. Wait until the control lamp 4 goes out.
6. Switch the appliance off with the On/Off switch 8
and then clean the appliance as described in
"Cleaning and Care".
The Tea Automat is now ready for use.

Operation

Attention:
DO NOT put any sugar into the Tea Automat.
DO NOT heat milk or alcohol in the tea automat.
This would irreparably damage the appliance.
Note:
Green tea is not suitable for brewing in the Tea
Automat. The ideal brewing temperature for green teas
lies at around 70°C. At higher brewing temperatures,
such as those generated in the Tea Automat, tannic
acids are released. The tea will taste bitter.
1. Remove the glass pot 3 from the base 5.
2. Open the lid 1 and take out the brew system.
Place the brew system on a level and even surface.
3. Pour the desired quantity of water into the glass
pot 3. NEVER fill it with more water than to the
MAX marking, and never with less than to the
MIN marking.
Danger!
To avoid scalds/burns and electric shocks, ensure
that water does not overflow from the glass pot 3.
4. Take hold of the brew system and pull the water
riser pipe q with the sieve w upwards.
5. Place the necessary amount of tea or number of
teabags in the brew chamber 0.
Note:
Ensure that no labels or teabag strings remain in the
appliance.
6. Replace the brew system in the glass pot 3.
Ensure that the water riser pipe q sits firmly in
the recess on the bottom of the glass pot 3.
The brew chamber 0 must be positioned with
the flattened side towards the handle 2.
7. Close the appliance lid 1.
8. Replace the glass pot 3 back on to the base 5.
9. Insert the plug into a wall power socket and place
the On/Off switch 8 at the position "I". The
control lamp 4 and the On/Off switch 8 light up.
The water is now boiled and forced upwards
through the water riser pipe q to flow through the
brew chamber 0 and then back into the glass pot 3.
- 13 -