Items Supplied; How To Use; Before Using For The First Time; Using The Kettle - Silvercrest SWKD 2200 A1 Bedienungsanleitung

4. Items supplied

1 Kettle 2
1 Device base 4
1 Set of operating instructions

5. How to use

DANGER! Risk of electric
shock!
Connect the mains plug only to a cor-
rectly installed, easily accessible
earthed wall socket with voltage corre-
sponding to the rating plate. The wall
socket must continue to be easily acces-
sible after the device is plugged in.
Pull the mains plug 6 out from the wall
socket after every use.
• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Place the device on a dry, level, non-slip
surface.
6. Before using for the
first time
1. Fill the kettle 2 up to the marking
MAX 1.7L on the water level display 3
and heat the water (see "Using the kettle"
on page 6).
2. Pour the water out and rinse out the ket-
tle 2 with fresh water.
3. Repeat this process. Then it is safe to
use the device.
6
GB

7. Using the kettle

DANGER! Risk of injury
through scalding!
It is always necessary to close the lid 9
when heating water, as boiling water
may otherwise spray out!
Do not open the lid 9 while the water is
boiling.
Fill the kettle 2 only to the maximum fill-
ing level (MAX 1.7L), as boiling water
may otherwise spray out.
Do not bend over the kettle 2 when you
open the lid 9 and the contents are still
hot. There is a danger of being scalded
by escaping steam.
The kettle 2 becomes very hot during
operation. Only touch it at its handle 7
and only use the release button 8 and
the on/off switch 5.
WARNING! Risk of material damage!
Fill the device with a minimum of 0.7 li-
tres of water (Marking MIN 0.7L), as
otherwise the device may overheat.
Never put alcohol, sugar or milk into
the kettle 2!
Water as foodstuff
Water is a very sensitive foodstuff and can go
bad due to germs forming. Please take note:
• Always use fresh drinking water in the
kettle 2.
• Pour water away, which has been
standing in the kettle 2 for longer than
approx. 1 hour.
• Do not reboil cooled down water.
Boiling water
1. Remove the kettle 2 from the device
base 4.
2. Press the release button 8 to open the
lid 9.
3. Fill the desired amount of fresh drinking
water into the kettle 2. Keep it upright