For The Safety Of Your Child; Before Using For The First Time - Silvercrest SFM 840 A2 Bedienungsanleitung

RP96745 Fritteuse mit Fondue LB6so Seite 7 Mittwoch, 26. Februar 2014 3:41 15
(lower marking MIN = minimum, upper
marking MAX = maximum).
• The appliance must never be placed
immediately beneath a wall socket as
the heat it generates could damage the
electrical installation.
• Never leave the appliance running
unattended. Damage is almost always
indicated by intensive odours. In this
case, disconnect the power supply
immediately and have the appliance
examined. You will find the service
address in "Service
page 14.

4.6 For the safety of your child

Warning! Children are often
unaware of danger and are injured
as a result. Please note therefore:
• Only allow children to use this device
under the supervision of an adult.
• Ensure the machine is always kept out of
the reach of children.
• Ensure that a child cannot pull down or
tip the appliance onto himself or herself.
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing film is not a toy.
1. Please clean the individual parts of the
deep-fat fryer
"9. Cleaning" on page 11).
2. Then carefully dry the individual parts.
SFM 840 A2
4.7 Protection against scalds and burns
• All parts must be completely dry before
• You should ideally use frying oil or liquid
Centre" on
• If you use solid frying fat, you should first
• You must only use oils or fats that do not
• Hot steam is released during the frying
• The fat may start spitting when melted
• If you wish to move the appliance, switch

5. Before using for the first time

thoroughly (see
Warning! As the appliance
operates at high temperatures,
please observe the following
safety information so that you do
not burn or scald yourself.
you pour oil or liquid fat into the deep-
fat fryer. Otherwise the heated fat could
spit badly.
frying fat.
melt the blocks of fat slowly in a normal
pan in order to avoid overheating and
the fat spitting. Then pour the melted fat
carefully into the deep-fat fryer before
switching the fryer on.
foam and that are suitable for frying.
Please refer to the packaging or label
for further information.
process. Maintain an adequate distance
from the steam.
again if it is too cold! Avoid this by
making some holes with a fork in the re-
solidified fat. Be careful not to damage
the fat container 6 while doing so.
it off, pull out the plug and wait until the
appliance has cooled down.
7