B) Operation As A Hazer - Renkforce HF-900 HAZER Bedienungsanleitung

• When the device is on, the POWER (8) switch lights up. The display (10) comes on and shows the software version.
• HEATING appears with a percentage of 0-100%. The device heats up now.
• Heating up takes a few minutes.
• When the device has reached its operating temperature, MACHINE READY will appear in the display (10).
• The device can be operated as a hazer (production of a haze effect) or as a fog machine (production of dense fog).
• For hazer operation, the switch HAZE/FOG (12) must not be pushed; for operation as a fog machine, it must be
pushed.

b) Operation as a hazer

Operation at the Device
Timer Operation
• Push the FUNCTION (11) button to make several pre-settings for timer operation:
- Push 1x to set the pause time of the working interval with the
- Push 2x to set the emission time of the working interval with the
- Push 3x to set the haze volume with the
- Push 4x to set the fan speed with the
- Push 5x to set the DMX starting address for DMX operation as described below with the
buttons.
• The TIMER (16) button starts timer operation with the above settings.
• The settings can be adjusted by pushing the FUNCTION (11) button and changing the values with the
and (14) buttons as well during timer operation.
• To interrupt timer operation, push the
Manual Operation
• Push the VOLUME PUMP/FAN (17) button to operate the device manually (without a timer).
• The device starts in manual operation.
• Push the FUNCTION (11) button to change the parameters HAZE (haze volume) and FAN (fan speed). The chosen
parameter is marked with a star in the display (10).
• Adjust the selected parameter with the
• To interrupt manual operation, push the
(13) and (14) buttons.
(13) and (14) buttons.
(15) button.
(13) and (14) buttons.
(15) button.
(13) and (14) buttons.
(13) and (14) buttons.
(13) and (14)
(13)
27