Mains Connection; Operation; A) Preparation - Renkforce HF-900 HAZER Bedienungsanleitung

b) Mains Connection
If the mains plug is not accessible anymore for disconnecting the device from the mains after installation
or if it is accessible but with difficulty for disconnecting the device from the mains, the voltage supply must
be separated from the mains via an all-pole switch.
Ensure that the voltage indication on the device matches the mains voltage of your power supply. Never try
to operate the device with any other voltage.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause potentially fatal
electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
• Connect the mains cable low-voltage plug to the mains connection (9).
• Plug the mains plug of the mains line into a mains socket with a protective ground contact for operation of the
device. However, do not plug in the mains plug. Before connecting the device to the power supply, you first have to
fill the tank with fog liquid (see "Operation/preparation").

10. Operation

a) Preparation

Always pull the mains plug before filling the tank.
Never fill the tank with flammable liquids or add such to the fog fluid. Only ever use suitable water-based
fog liquids (the CONRAD range features suitable fog liquids, see "Technical Data").
Never tilt the device. Fog liquids may leak out or enter the inside of the device and cause damage there or
injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid. This may cause
damage to the device and potentially fatal electrical shock.
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank.
The tank can be taken out of the holder at the device for filling.
• Unscrew the tank closure lid again and put the tank back into its holder at the device if necessary.
• Align the fog exit (2) as desired. The ejection angle of the fog exit (2) can be changed.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch on the device with the POWER (8) switch (switch in I position).
26