Operation - Renkforce B-400 Bedienungsanleitung

10. Operation

Always pull the mains plug before filling the tank.
Never fill the tank with flammable liquids or add such to the fluid. Use only suitable water-based
fog liquids (for suitable fluids, see online on the product page under "Accessories").
Never tilt the device. Liquids may leak out or enter the inside of the device and cause damage
there or injure the operator.
Make sure that no fluid enters the inside of the device when you are filling it with fog liquid. This
may cause damage to the device and potentially fatal electrical shock.
If no fog emerges, the device is still warming up or reheating (the fog button (6) on the remote
control is not lit).
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a
defect.
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank.
• Then screw on the tank closure lid again.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch on the device with the mains switch (3) (set switch to ON position). With the device on, the mains
switch lights up and the fog machine heats up.
• Heating up takes approx. 4-5 minutes.
• Once the device has reached its operating temperature, the fog button (6) on the remote control is lit and
the device is ready for operation.
• Push the fog button (6) at the remote control to trigger the fog function. In the model B-400 LED fog ma-
chine, an LED light effect is tripped at the same time as the fog function, using the effect LEDs (8). The
LEDs will remain lit while the fog button (6) is pushed.
• Ensure that the tank never runs empty during fog operation. Should this happen nevertheless, turn the
device off immediately using the mains switch (3) (put the switch in the position OFF) and let it cool
down.
• Only top up the tank after the device is cooled off. The fill level of the tank is evident at the tank fill level
display (5).
• Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a defect.
• If you no longer require the device, disconnect the mains plug and let the device cool down.
• Then empty the tank if the device is not used for any extended period. This prevents leaking of fog liquid
during transport or storage.
24