Renkforce HF-900 HAZER Bedienungsanleitung Seite 29

DMX Operation
• Push the FUNCTION (11) button 5x as described above and set the DMX start address.
The DMX start address can be set from 1 to 510 and defines the first channel to which the device reacts.
• You can now control the device from your DMX controller. For the functions of the individual channels, see the
following table.
DMX channel Value
1 0-255
2 0-255
3 0-127
128-255
Ensure that the tank never runs empty during fog operation. Observe the fill level display (7) for this.
If this happens anyway, the message BEWARE: NO LIQUID will appear in the display (10). Switch off the
device without delay using the POWER (8) switch in this case and let it cool off.
Refill the tank after cooling.
If no fog or haze emerges, the device is still warming up or reheating.
Slight fog lag after deactivation of the device is normal and does not suggest a defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank if the device is not used for any extended period. This prevents leaking of fog liquid
during transport or storage.
Function
Fog amount 0-100 %
No function in fog operation
Fog operation off
Fog operation on
29