Electrical Connection - Renkforce A-2001 Bedienungsanleitung

Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Set up the fog machine under observation of the above safety notes.
• The fog machine can also be suspended with the enclosed assembly bracket. Always observe horizontal
installation for this.
b) Electrical Connection
The mains socket to which the device is connected must be easily accessible so that the fog
machine can be separated from the mains voltage quickly in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause po-
tentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Convince yourself that the device is switched off before you connect it to the power supply.
Ensure before plugging in the mains plug that the device voltage indicated on the rating plate
corresponds to the available mains voltage. Do not connect the device if the indication does
not correspond to the available mains voltage. Incorrect supply voltage may lead to irreparable
damage to the device and danger to the user.
• Install the connection cable for the remote control up to the site from which you are going to control the
device.
• The rear of the remote control is magnetic. The remote control thus sticks to metal objects.
• If you want to control the fog machine via an external DMX controller, connect the DMX IN (6) connec-
tion to the output of your DMX controller.
• Connect DMX OUT (4) with the DMX input of the subsequent device. If the fog machine is the last or only
device in the DMX chain, plug a plug with end resistors in here.
• Plug the mains plug into a mains socket with a protective ground contact for operation of the device.
However, do not plug in the mains plug. Before connecting the device to the power supply, you first have
to fill the tank with fog liquid (see „Operation").
23