Electrical Connection - Renkforce 1386535 Bedienungsanleitung

Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be checked by an official expert.
A yearly check by a technical expert is required.
At least every four years, a quality inspection must be carried out by an official expert.
• Set up the fog machine observing the safety instructions mentioned above and mount it with the instal-
lation bracket on the ceiling, the wall or a suitable crossbeam. Make sure that the device cannot swing
freely.
• Attach the device with installation material suitable for the installation surface and capable of bearing
the load of the fog machine.
• Secure the installation with a suitable safety rope. The safety rope must be designed to retain the device
if the main suspension fails.
• Align the fog machine horizontally and properly tighten the bracket clamping screws.
• The maximum permissible tilt angle of 15° must not be exceeded.
b) Electrical Connection
If, after the fog machine has been mounted, the mains plug is not anymore easily accessible, the
voltage supply must be separated from the mains via an all-pole switch.
Do not leave cables lying or hanging around. Have them installed professionally to prevent
accidents.
• Install the cable for the remote control up to the site from which you intend to control the device.
• The back of the remote control is magnetic. Therefore, the remote control sticks to metallic objects.
• The mains plug must be plugged into an earthed power outlet to operate the device. However, do not plug
in the mains plug yet. Before connecting the device to the power supply, fill the tank with fog liquid (see
„Operation").
20