Fuse Check/Replacement/Reset - Nilfisk-ALTO FLOORTEC R670 P Betriebsanleitung

ENGLISH

FUSE CHECK/REPLACEMENT/RESET

1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (82) to "0".
3. Open the hood (7).
4. Disconnect the battery negative connector (43).
Lamellar fuse check/replacement
1. Remove the fuse box cover (46).
2. Check/replace the relevant fuse among the following (Fig.
18):
(A): F1 main fuse (key circuit) (15 A)
(B): F2 fi lter shaker motor fuse (25 A)
(C): F3 manual vacuum system fuse (40 A) (optional)
(D): F4 vacuum system motor fuse (30 A)
(E): F5 horn and pivoting light fuse (10 A)
(F): F6 working light fuse (10 A) (optional)
3. Remove the electrical component box cover (50).
4. Check/replace the following fuse (Fig. 19):
(A): FT drive system fuse (70 A)
5. Remove and check/replace the following fuse (63):
FR charging system fuse (70 A)
Fuse check
1. Check one of the following fuses (Fig. 18) for deactivation:
(G): FA main broom motor fuse (30 A)
(H): FB side broom motor fuse (10 A)
Reset any deactivated fuse, when the component that
caused deactivation has fully cooled down.
2. Close the hood (7).
22
USER MANUAL
FLOORTEC R 670 P
G
A B C D E
Figure 18
Figure 19
1464031000(1)2009-04 A
H
F
P100348
A
P100349