Main Broom Replacement - Nilfisk-ALTO FLOORTEC R670 P Betriebsanleitung

ENGLISH

MAIN BROOM REPLACEMENT

NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
CAUTION!
It is advisable to wear protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (82) to "0".
3. Unscrew the knobs (23) and remove the right door (22).
4. Loosen the knob (A, Fig. 3).
5. Unscrew the knobs (B, Fig. 3) and remove the broom
compartment cover (C).
6. Remove the broom (A, Fig. 4).
7. Check that the drive hub (A, Fig. 5) is free from dirt or
foreign materials (ropes, rags, etc.) accidentally rolled up.
8. The new main broom must be installed with the bristles
rows (B) bent as shown in the fi gure.
9. Install the new main broom (C, Fig. 5) and ensure that the
mesh (D) correctly fi ts into the relevant drive hub (A).
10. Install the broom compartment cover (C, Fig. 3) and
tighten the knobs (B) and (A).
11. Install the right door (22), then tighten the knobs (23).
12. Check and adjust the main broom height as shown in the
previous paragraph.
18
USER MANUAL
FLOORTEC R 670 P
A
C
B
Figure 3
Figure 4
Figure 5
1464031000(1)2009-04 A
B
S311391
S311392
S311393