Herunterladen Diese Seite drucken

Squeegee Cleaning; Squeegee Blade Check And Replacement - Nilfisk-ALTO SCRUBTEC 343E Betriebsanleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
1.
Drive the machine on a level fl oor.
2.
Make sure that the power supply cable (21) is disconnected from the electrical mains.
3.
Lower the squeegee with the lever (19).
4.
Disconnect the vacuum hose (22) from the squeegee.
5.
Loosen the handwheels (12) and remove the squeegee (11).
6.
Wash and clean the squeegee. In particular, clean the compartments (A, Fig. 4) and the vacuum hole (B) from dirt and debris.
7.
Check the front blade (C) and the rear blade (D) for integrity, cuts and tears; if necessary replace them (see the procedure in
the following paragraph).
8.
Assemble the components in the reverse order of disassembly.

SQUEEGEE BLADE CHECK AND REPLACEMENT

1.
Clean the squeegee as shown in the previous paragraph.
2.
Check that the front blade edges (E, Fig. 4) and the rear blade edges (I) lay down on the same level, along their length; if
necessary adjust the height according to the following procedure:
Remove the mounting springs (F), then adjust the front blade (C) and the rear blade (D).
Install the mounting springs on the front and rear blades.
3.
Check the front blade (C) and rear blade (D) for integrity, cuts and tears; if necessary replace them as shown below. Also
check the front corner (H) of the rear blade for wear; if it is worn, overturn the blade to replace the worn corner with the other
one (I), if it is integral. If the other corner is worn too, replace the blade according to the following procedure:
Remove the mounting springs (F) and then replace (or overturn) the rear blade (D).
Install the mounting springs on the front and rear blades.
4.
Install the squeegee (11) and screw tighten the handwheels (12).
5.
Connect the vacuum hose (22) to the squeegee (11).
5
9
12
909 6315 000(4)2009-11 A
1
7
USER MANUAL
2
6
Figure 4
SCRUBTEC 343E
ENGLISH
4
1
6
15
3
S310240

Quicklinks ausblenden:

Werbung

Fehlerbehebung

loading