Stromversorgung Des Dd; Using Batteries; Using An Optional Power Adaptor - Yamaha DD-14 Bedienungsanleitung

Supplying Power to the DD-14
Your DD-14 Digital Percussion unit will operate on either
batteries or an optional
instructions below for the power source you intend to use.

Using batteries:

Open the battery compartment cover located on the bottom
of the DD-14 and insert six "C size (SUM-2 or R-14)
batteries or equivalent (sold separately), being careful to
orient them as shown
compartment. Then replace the battery compartment cover,
making sure that it locks firmly in place.
Cautions:
• When the batteries run down, replace them with a
complete set of six new batteries. NEVER mix old and
new batteries. Do not use different kinds of battenes at
the, same time.
You will know it is time to replace the batteries with fresh
ones when the following symptoms occur:
1. The DD-14's instrument sounds become distorted.
2. The DD-14 resets its settings to their initial values for
no apparent reason.
To prevent damage due to battery leakage, remove the
batteries from the instrument when it is not to be used for
an extended period of time.

Using an optional Power Adaptor:

Plug the DC output cable from an Yamaha PA-3, PA-4, or
PA-40 Power Adaptor into the DC IN jack on the DD-14 rear
panel, then plug the adaptor into a convenient AC power
outlet.
Use ONLY a Yamaha PA-3, PA-4, or PA-40 Power Adaptor to
power your DD-14 with AC mains power. Other AC adaptors
could cause serious damage to your Digital Percussion unit.
power adaptor. Follow
by the markings inside

Stromversorgung des DD-14

the
Bateriebe trieb
the
Betrieb mit einem optionalen Netzadapter
m