Custom Percussion Sets; Selbst Programmierte Percussion Sets - Yamaha DD-14 Bedienungsanleitung

1. Check to make sure that the indicator above the
STYLePERCUSSION SET button @ is not lit. If it is lit.
press the STYLE/PERCUSSION
indicator will go out, and the number of the current
percussion set will appear in the display (j).
Note: Percussion set 00 (BASIC) is automatically selected
each time you turn the POWER switch (s) on.
2. Use the number buttons @ to enter the number of the
desired percussion set (00 through 29).
Always enter two digits to select a percussion set. For
example, to select set 03 (HARD ROCK), press the "0"
button and then the *3" button. The new set will be selected
as soon you enter the second digit of its number.

3.3 Custom Percussion Sets

The DD-14 allows you to assign any of its 75 instrument
sounds to any of the percussion pads d). In addition, you can
assign any of the non-melody percussion instruments (00
through 64) to the foot pedal.
You can also assign the functions normally performed by the
FILL IN buttons ® and the INTRO/ENDING button ® to any
of the percussion pads or the foot pedal. The functions of
these buttons are explained fully in the following chapter.
The DD-14 lets you create and store up to five different
percussion sets at any one time. You can store the sets you
create as the sets labeled CUSTOM 1 through CUSTOM 5
(sets 25 through 29). The DD-14 will keep your custom sets
in its memory even when the power is turned off.
The instruments and functions available for assignment are
listed in the chart below, as well as on the Instrument List
card which accompanied this manual.
21
SET button. The
O
STYLE/PERC. SET/SCR.
STYLE
D
PERC.
SET
o o o o
1 2 3
o o o o
6 7 8
1.
n n
u u
CßEÄH
2.
O
STYLE/PERC. SET/SCn.
4
5
n a
b
U J
O
'-SEAT-l
9 0

3.3 Selbst programmierte Percussion Sets