Eaton 9910-E83 Installationsanleitung Seite 71

Chapter 3 Communication
The E82/E83 UPS is equipped with a USB port, a REPO port, two DB-9
communication ports, and an X-Slot communication bay (see Figure 35).
Two parallel ports are available for future use.
Either the USB port or the RS-232 DB-9 communication port may be
used to monitor the UPS; however, they cannot operate simultaneously.
The service DB-9 port is used only to upgrade the firmware.
The X-Slot communication bay can accommodate any X-Slot card and
can operate simultaneously with the USB port or RS-232 communication
port.
USB Port DB-9 Communication Ports Parallel Ports (for future use)
Service Only
REPO Port X-Slot Communication Bay
(REPO connector installed)
Figure 35. Communication Options
S
® ® 55
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM Applications 164201715 Rev 2
www.eaton.com/ibm