Renkforce 751074 Bedienungsanleitung Seite 62

Code for switching the "Coercion communication output" and output 1
This code is generated by adding the value "2" to the first digit of user code 1.
These codes are used to achieve a further coercion communication. With every code
entry the normal switch function follows and another coercion communication contact
is activated. This coercion communication contact ("DU OUT") can only be deactivated
with the "normal" User-Code 1. In this case the relay does not switch, it is only reset
to the output "DU OUT".
:
Example
If user code 1 is "1234" then the code is "3234"
In the programming example above, the programmed user code 1 is "8321" and so the
code "0321" must be used
0 3 2
Using the short code
If you have programmed an output to allow the use of the short code (42#, 52#, 62#)
then you can switch the output using only the first two digits of the user code. The
short code can be used to switch all three outputs, but take note of the programming
that you have done.
The respective full user code must be entered in order to switch the relay(s) off again.
In the programming example, output 3 was programmed to allow the use of the short
code. User code 3 is "9270" and so the short code is "92"
9 2 #
9 2 7
62
.
1 #
0 #
.
Relay 1 engages for 5 seconds and the "DU
OUT" output switches to ground.
.
Output 3 switches on
Output 3 switches off