Renkforce 751074 Bedienungsanleitung Seite 44

Load capacity of outputs:
OUTPUT 1
OUTPUT 2
Sabotage contact
EG IN
DOOR BELL
O/P 1. INHIB. "Input con-
trol" OUTPUT 1
INT. LOCK Output control
for Two-door system
KEY ACT Key-Alarm
DU OUT coercion contact
"DURESS"
"EGRESS contact": If this terminal is connected to the ground potential then "OUTPUT
1" switches according to your programming.
This contact is useful when you wish to open a door from the inside that is controlled
by "OUTPUT 1".
In alarm systems there are two types of contact, designated with "NO" and
"NC".
N.O. (Normally Open): When standby the contact is open
N.C. (Normally Close): When standby the contact is closed
The following table describes the connections in the connector strip (1) and gives ex-
planations.
44
30 V (AC/DC), 5 A
30 V (AC/DC), 1 A
Current-free NC contact for a 24 h alarm loop
NPN open-collector contact, 24 V/DC, 100 mA. Swit-
ches to minus potential (-)
30 V (AC/DC), 1 A
NPN open-collector contact, 24 V/DC, 100 mA. Swit-
ches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA. Swit-
ches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA. Swit-
ches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA. Swit-
ches to minus potential (-)