B) Starting The Measurement Process; C) Starting The Measurement Process Again With The Same Time Period - VOLTCRAFT SEM4500 Bedienungsanleitung

b) Starting the measurement process

• Start by setting the time period, see Chapter
10. a). In the example to the right, a time period
of 3 days has been set.
• When no indicator is flashing, start the meas-
urement process by briefly pressing the
button (4).
• The display switches back to the measured
values. During the automatic measurement
process, "PERIOD" flashes on the display, see
the arrow in the figure to the right.
• You can, as usual, use the
formation.
c) Starting the measurement process again with the same
time period
To start another measurement process with the same, previously set time period,
proceed as follows:
• Briefly press the
for the measurement process appear on the display.
• Briefly press the
• Briefly press the
• Briefly press the
• Start the measurement process by briefly pressing the
also Chapter 10. b).
button (6) or
button (4). "PERIOD" and the currently set time period
button (3), the day flashes.
button (3), the hours flash.
button (3), setup mode is ended, no indicator flashes.
button (7) for more in-
button (4) (see
63