G) Setting The Co Emissions - VOLTCRAFT SEM4500 Bedienungsanleitung

g) Setting the CO
Here, you can enter the CO
respective electricity tariff (for example 0.480 kg/kWh) can be found on your elec-
tricity provider's website.
If you have an electricity tariff with 100% electricity from sustainable
resources, entering 0.000 kg CO
You can enter a value for the CO
The energy cost meter then shows how much CO
provider of energy from sustainable resources.
Depending on the power consumption, the energy cost meter shows the respec-
tive CO emissions generated during operation of the connected load.
2
• If you have set the standby limit value (see Chapter 8. f) before setting the CO
value, you can proceed directly to the next step.
Otherwise, setup mode must be started, see Chapter 8. c). Press the
button (7) three times to go to setting of the CO
• Briefly pressing the
times selects the input position for the CO
value (the selected input position flashes).
• Change the flashing value with the
(6) or button (7). After confirming the last
input position, the display stops flashing.
• If no indicator is flashing, you can jump to the next setting by briefly press-
ing the (7) button or exit the setup menu by briefly pressing the
button (2).
emissions
2
emissions per kWh. The value applicable to your
2
button (3) several
/kWh is not appropriate.
2
emissions of a normal electricity tariff.
2
value, see the next step.
2
2
button
is saved by using a
2
55
2