VOLTCRAFT SEM4500 Bedienungsanleitung Seite 58

• If you have set the overload alarm (see Chapter 8. h) before setting delete
mode, you can proceed directly to the next step.
Otherwise, setup mode must be started, see Chapter 8. c. Press the
button (7) five times to open delete mode, see the next step.
• "CLr" appears on the display.
Briefly press the
appears at the bottom of the display.
• Use the
to select one of the two delete functions "CLr
dAtA" and "CLr SEt".
The data that is deleted is outlined at the
start of Chapter 8 i).
• To delete the selected data, press and hold the
button (4) for 3 seconds until a beep is
heard. The selected data is deleted. "CLr" ap-
pears on the display again.
If you want to interrupt delete mode without
deleting data, briefly press the
"CLr" appears on the display.
• If no indicator is flashing, you can go to the start of setup mode (time setting,
see Chapter 8. d) by briefly pressing the
by briefly pressing the
58
button (3), "CLr dAtA"
button (6) and
button (2).
button (7)
button (3).
(7) button or exit the setup menu