Busch-Jaeger Busch-Wachter 180 Betriebsanleitung Seite 57

Installation
IMPORTANT
In order for your device to become fully operational, after
installation, the terminals of the FM Insert must be in the
correct position at the bottom of the FM box (see also Fig. 1).
Assembly
To assemble, proceed as follows:
• After setting has been completed, remove the adaptor.
• Attach Sensor 6800-3x / (Fig. 1, Pos. 4) and the frame
(Pos. 3) to the FM Insert (6401 U - 102 only) in such a way
that the back of the plug-in connection is not canted, and
snap into place.
• Using the special key provided, screw Sensor 6800-3x
tight by means of the enclosed "Torx" screws.
Dismantling
To dismantle, loosen the "Torx" screws and lift Sensor
6800-3x out of the FM Insert - always together with the
frame.
GB