Motion Detection - Conrad 75 17 71 Bedienungsanleitung

Stop/Set (8)
Enter/Time (4) Press this button shortly to display (13) the time.
RESET (12)

12. Motion detection

The control switch for motion detection (3) allows you to make the following settings:
Switch position
H (High)
M (Middle)
L (Low)
If the control switch for motion detection (3) is in position M or
L, recording starts when motion is detected.
Recording stops if no motion is detected for 10 seconds.
30
Press this button shortly to stop the current recording and put the
surveillance camera in standby mode.
Hold down the button for about three seconds to set the video stan-
dard (PAL or NTSC). PAL is common in Europe and Australia.
Hold down this button for about three seconds to edit the time. (see
chapter "Setting time and date").
Press this button to delete all video files.
Sensitivity
Continuous recording
High-sensitivity motion detection
Low-sensitivity motion detection