Operation; Emptying And Service - Gloria Hobby universal Handbuch

GB

Operation

GRemove the pump by turning it to the
left. Before doing this release pump
rods, turn them 180° and transmit
the srew force via the back of the
zwistlocks on the pump housing.
GFig. J (hobby exclusiv 262)
Take filler sieve from the support at
the filling funnel and clip it into the
charging hole of the filling funnel.
GFilling of the container. Attention!
Max. liquid capacity (see technical
data) and the correct dosage of the
chemicals manufacturer have to be
observed.
Ghobby exclusiv 262
Remove filler sieve and clip it into the
support at the filling funnel.
GRe-insert pump and tighten.
G Operate pump until a working pres-
sure of 3 bars is reached.
G Depressurize the pump and lock the
pump rod by turning to the right with
the pump housing. Note: only carry
the unit in a locked state.
G For spraying press down the opera-
tion lever at the valve body. When re-
leasing the lever the output will be
interrupted.
Information card
G Fig. K: Fill in the information card to
document the date of filling and type
of spraying agent.
Emptying and
Service
GAny residual pressure in the tank can
be vented by lifting up the knob on
the safety valve.
G The pomp will be carefully, at first
only a few turns by lefthand rotation
screwed off, so that the compressed
air being still in the tank can deflate.
G After use clear apparatus carefully
and dry it in open state.
G The working life will be extended
when greasing the washers and col-
lars sometimes. Only use resin- and
acid-free grease.
GFor easy cleaning and safe
neutralization of remaining
liquid is recommended to use
GLORIA special powder, art.-
no. 263.0000.
14