Definition Of Dip-Switch Positions For Defined Dmx-Addresses; Changing Of Gobos; Gobo Measurements - JB-Lighting Varyscan 4 1200HMI Bedienungsanleitung

Varyscan
11
12

Definition of DIP-switch positions for defined DMX-addresses

Every single DIP-switch
you would like to adjust a defined DMX-address, you have to add up the single figures to get it.
For example: DMX-address "45"
32 + 8 + 4 + 1
SW6 SW4 SW3 SW1
on on
All remaining DIP-switches SW9 SW8 SW7 SW5 SW2 stay in position "OFF".

Changing of gobos

Open the lid with the label Varyscan
press the gobos at the gobo wheel out of their holder and then put in other gobos. Take care that the
gobo engages exactly with it's slits in the holder. If the gobo is put in correctly, it moves easily inside
the holder. Now you can close the lid.

GOBO measurements

®
With your Varyscan , you have the chance of using two different gobo sizes.
®
4 1200 HMI
81
89
= 45
on on
®
4 1200 HMI, by screwing off the six screws. Now you are able to
responds to the above designated figures. If
33