Paragraph 3 - Timed Dosage (Frequency Signal Input "Trigger" Activated) - Oase Clear Fountain System CFS 50434 Gebrauchsanleitung

Pos: 77 /Gartentechnik/KDS Anlage TEKNA/Absatz 3 – Getaktete Dosierung (Eingang Frequenzsignal "TRIGGER" aktiviert) @ 11\mod_1253630525640_121.doc @ 75022 @
7. Paragraph 3 – Timed Dosage (Frequency signal input "TRIGGER" activated)
Programming
PROG
Configuration
Configuration
Pump functions
-
+
Pump functions
Time
Time
-
Quantity 100ml
Time g.hh.mm
-
Delay 0.01.50
Time g.hh.mm
-
interv. 0.01.50
Trigger Mode
-
N. Open
Pause Input Mode
-
Trigger Mode
Display during Operation
Operating mode
•
Timer
Alarms and statuses
•
Liv = level alarm
•
Flow = flow alarm or
....Release wait
Pos: 78 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @
-
+
-
+
-
+
Trigger Mode
-
N. Open
Trigger Mode
-
N. Closed
Trigger Mode
Disable
FLOW
Programmed value
sensor status
•
Quantity in ml
Timer F F F 7,0 ml
Stop P 0%
Value of the dosing in
progress
Pump status
•
Dry = pump starting up
•
Stop = pump stop
•
Restart = pump restart
Operation
After receipt of the TRIGGER signal set, the pump doses a quantity
that can be programmed in ml. It is possible to set a delay time
before the dosing (Delay) and the interval between subsequent
dosings (Interv.) as illustrated in the diagram:
Trigger
Delay
By setting for example an Interval. time = 0, a system is obtained in
which the programmed quantity is dosed after each TRIGGER
signal (with any delay that has been set):
Trigger
Delay
It is possible to start the dosing by pressing the + key, which, in
practice, simulates the Trigger signal.
The Trigger signal can be set to N. Open (it is activated when the
input passes from the open to the closed mode) or to N. Closed (it
is activated when the input passes from the closed to the open
mode).
The Trigger signal is locked during dosing (its receipt is neither
stored nor managed).
The Pause (Remote input) input cannot be programmed and its
activation stops the dosing, while its further deactivation makes the
system wait again for the Trigger signal for a new dosing.
The dosage frequency can be modified while the pump is operating,
by pressing the
frequency, or the
Display during Setting (MODE key)
•
The following are shown in sequence:
quantity to dose, delay in d.hh.mm.
and interval in d.hh.mm
Q.tà
20,0ml
•
Percentage of
strokes/min
max
Value of the dosing percentage,
which can be modified by
pressing the + or – keys
Quantity
Interv.
Release
Ritardo
keys at the same time to increase the
keys to decrease it.
Operating mode
Dosing value
•
Programmed
20,0ml
P 100% quantity in m
- GB -
l
29