Control Panel - Anti-Algae Dosing Pump - Oase Clear Fountain System CFS 50434 Gebrauchsanleitung

- GB -
Pos: 68 /Gartentechnik/KDS Anlage TEKNA/Steuertafel TEKNA @ 11\mod_1253627331597_121.doc @ 74914 @
2. Control Panel – Anti-Algae Dosing Pump
Access to the programming menu
When pressed during the pump operation phase, it cyclically displays the programmed values on
the display; When pressed at the same time as the
dependent on the selected operating mode. During programming it carries out an "enter" function,
meaning that it confirms entry to the various menu levels and modifications within the same.
Starts and stops the pump. In the event of a level alarm (alarm function only), flow alarm and active
memory alarm, it deactivates the signal on the display.
Used to "exit" the various menu levels. Before definitively exiting the programming phase, you will b
asked if you wish to save any changes.
Used to run upwards through the menu or increase the numerical values to be changed. Can be
used to start dosage in Batch mode
Used to run downwards through the menu, or decrease the numerical values to be changed.
Flashing green LED during dosage
Red LED that lights up in various alarm situations
B
Pos: 69 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @
24
keys, it increases or lowers a value
1
Output relay
2
3
Not connected
4
5
- Remote control input (start-stop)
- Pause signal input
6
7
Trigger signal input
8
9
Flow sensor input
10
B Input level control