Telephoning; Setting The Ringing Volume; Setting The Receiver Volume - switel POWERTEL TF 520 Bedienungsanleitung

5 Telephoning

Taking a call
If a call is received, the Call/SOS LED flashes.
The flashing of the Call/SOS LED can be altered; . Menu Struc-
ture, Page 82 (RING LIGHT).
{ì}, è or w
or
z
If the caller number display (CLIP) is available on your telephone
line (. Page 81) and you have selected VOICE:ON via the
menu, the phone number of the caller is announced prior to the
ringing tone.
If the phone number of a caller has been stored in the phone book
(. Page 83) and a name vocally recorded for it, the name recor-
ded is announced between the first two rings.
Displaying the duration of a call
The duration of a call is displayed in minutes and seconds during the call.
Ending a call
w or é
or (if the handsfree function is active)
z
Making a call
ë
b
è
or
c or w
Take the call
Take the call (handsfree function)
End the call
End the call
Enter the phone number
(max. 22 digits)
Delete the last digit if incorrect
Dial the phone number
Dial the phone number
(handsfree function)
It is also possible to pick up the receiver first to obtain the dialling
tone. The digits then entered are dialled immediately. It is not
possible to correct wrong digits individually using this dialling
procedure.

Setting the ringing volume

67
The ringing volume can be altered to one of 5 different volume levels using
the menu; . Page 82:
S
Level 0: Ringing volume off (mute)
S
Level 1: Ringing volume quiet
S
Level 4: Ringing volume loud

Setting the receiver volume

Adjust the receiver volume using the slide control which is located under-
neath the receiver when on the base unit:
S
Slide control to the left: Receiver volume becomes quieter.
S
Slide control to the right: Receiver volume becomes louder.
Amplifying the receiver volume to +40 dB
The receiver volume can be increased to +40 dB by pressing the Ampli-
fication button.
v
v
You can use the menu to set−up the telephone so that the amplification is
set to +40 dB directly without the need to press the Amplification button.
Open the menu and select BOOST LOCK:ON; . Menu Structure,
Page 82.
Receiver tone control
The tone control only works when the receiver volume amplifica-
tion to +40 dB has been activated (amplification LED lights up).
You can adjust the tone produced in the receiver using a slide control on
the right−hand side of the housing.
Telephoning
68
Amplification on
Amplification off
75