Kärcher KMR 1250 D Bedienungsanleitung Seite 25

 Front sealing strip
 Unscrew fasteners of sealing strip.
 Remove the sealing strip.
 Screw on new sealing strip.
Note
The front sealing strip cannot be adjusted.
 Rear sealing strip
 Unscrew fasteners of sealing strip.
 Remove the sealing strip.
 Screw on the new sealing strip.
 Adjust sealing strip.
 Set the ground clearance of the sealing
strip to 1-5 mm.
 Screw on new sealing strip.
 Side sealing strips
 Unscrew the fasteners of the sealing
strips.
 Remove sealing strips.
 Insert new sealing strips.
 Adjust sealing strips.
 Set the ground clearance of the sealing
strip to 1-3 mm.
 Screw on new sealing strips.
Replacing dust filter
Danger
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
Note
A clear deposit of dust at the air exit of the
blower is an indicator that the dust filter has
not been inserted correctly or is defective.
 Raise waste container up to the half (1).
 Open catches (2).
 Tilt the filter box towards the front and
remove it (3).
 Fold up the handle (4), pull it out and
turn it by 90° (lock).
 Remove filter cartridge (5).
 Insert new filter cartridge; bolts must
have been inserted into the holes (6).
 Reset handle in the starting position and
lock it. Check correct position of the fil-
ter.
 Insert filter box and lock it.
Replacing electric bulb
 Stop the machine.
 Turn ignition key to "0" and remove it.
 Loosen the fasteners of the columns.
 Remove column (1).
 Loosen the screw between the struts of
the lamp holder of the defective head-
lights.
 Turn the diffusing lens of the defective
headlamp in the anti-clockwise direction
by approx. 1/4 rotation (2) and take out
the reflector housing (3).
 Take out the bulb.
 Insert new bulb.
 Insert the reflector housing from the bot-
tom into the column and fasten it by
turning approx. 1/4 rotation in the clock-
wise direction. Ensure that it has locked
in properly; the letters HALOGEN must
be clearly legible on the headlights
glass in a horizontal manner (4).
 Turn in the screw between the struts of
the lamp holder.
 Fasten the column.
Replacing fuses
Note
Only use fuses with identical safety ratings.
 Open the device hood.
 Replace defective fuses.
Note
Multiple defect of the same fuse indicates a
technical defect in the electrical system. In-
form Kärcher Customer Service.
25
English