Reely ROad Slim Dart Bedienungsanleitung Seite 36

1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Drive forwards and then go into reverse (wait briefly between the change (approx. 1 - 2 seconds) and leave the
lever in its neutral position!)
If the neutral position is not correct (e.g. trimming control slightly off), you cannot switch between forward
and reverse driving. If you have this problem, correct the trimming settings for the driving function at the
transmitter.
Observe that the speed controller recognises neutral position of the transmitter when activated.
Before switching on the speed controller, the driving function trimming therefore must be put about to the
centre position. Also release the throttle/brake lever (neutral position). Now you may switch on the speed
controller.
Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all.
This behaviour could be caused by low drive batteries, low batteries/rechargeable batteries in the remote
control or by too great a distance between vehicle and remote control.
A cut or damaged telescopic aerial, interferences on the radio channel used (e.g. radio transmissions from
other devices) or adverse transmission/reception conditions may also cause unusual responses of the
vehicle.
Since the receiver is supplied with power through the speed controller BEC and thus through the drive
battery, low or empty drive batteries will cause unintentional movement of the vehicle (e.g. twitching of the
steering servo, etc.).
36
Wait briefly