8. Commissioning
a) Installing the Receiver Aerial Cable
Insert the aerial cable into the included aerial tube.
Plug the aerial tube into the respective holder at
the vehicle (see arrow in the figure on the right).
Let any excess aerial cable protrude loosely from
the tip of the aerial tube.
Never shorten the aerial cable; this reduces the
range extremely!
b) Attach Tail Spoiler
The tail spoiler is fastened to the tail spoiler hol-
der with two clips.
First pull out the clips. Push the tail spoiler onto
the two holders and secure it with the clips you
removed first.
c) Inserting Batteries/Rechargeable Batteries into the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Observe
correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Observe the enclosed operating instructions for the remote control system.
d) Taking the Transmitter into Operation
Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
33