Getting Started And Installation; Installing The Camera - Sygonix 1533808 Bedienungsanleitung

7. Getting started and installation

These instructions refer to a smartphone. This is intended to mean an Android
smartphone, iPhone or iPad.
a) Installing the camera
• If you want to use 3G features, insert a SIM card into the lower card slot before turning the
camera on.
The side with the diagonal corner must be inserted in the slot first. The contacts of the SIM
card must be on the right-hand side of the slot.
Press the card into the slot (8) until it clicks into place.
To remove the card, press it until it unlocks, and then pull it out of the slot.
• A SIM card is not required to use Wi-Fi features.
Your smartphone must be connected to the same network as the camera in order to
use Wi-Fi features.
• Connect the micro USB cable to the micro USB port (9) on the camera.
• Plug the other end of the USB cable into the USB port on the USB power supply unit.
• Plug the power supply unit into a mains socket.
• The camera will turn on automatically when it is supplied with power (the LED indicator will
turn red).
To turn the camera on or off manually (e.g. when using the built-in battery), press the
on/off button (12) on the top of the camera for 3 seconds.
A sound will be played to indicate that the camera is switching on/off.
It is only possible to switch off the camera when it is not connected to the USB power
supply unit.
The battery charges automatically when the camera is connected to the USB power
supply unit.
• The LED indicator (1) will turn yellow (flashing yellow if a SIM card is inserted) when the
camera has finished switching on.
42
TM