Basic Settings; Initial Settings; Setting The Clock; Water Hardness Setting - Küppersbusch CDK6300.0 Bedienungsanleitung

1

Initial Settings

After your steam oven is first plugged in or after
a power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock and the
water hardness parameter is set.
To set the clock and the water hardness
parameter values proceed as described in the
following chapters (Note: The Function control
must be set to off):

Setting the clock

Before using the oven, adjust the clock to the
current time. To set the clock, proceed as
follows:
1. Press
Indicator Light starts to flash.
2. Press the OK key (6).
3.
correct hour value.
4. Press the OK key (6) to validate the hour
value. The minute numbers will start to
flash.
5.
correct minute value.
6. To finish, press the OK key (6) again.
36
a
3
4
-
-
b c d
5 6 7 8
Hiding / Displaying the Clock
If the clock display disturbs you, you can
hide it by proceeding as follows:
1. To hide the clock
-
The dots that separate the hours and
minutes and the clock symbol will be lit, but
the rest of the clock display will be hidden.
2. If you want to see the clock display again,
press the
seconds.

Water Hardness setting

The system can be optimised for households
with very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range
of water hardness (see table below). To set the
water hardness parameter, proceed as follows:
(The appliance
automatically indicates when it is time to
1. Rotate the Function Selector knob (1) to the
position corresponding
Hardness Setting / Descaling function (not
necessary after connecting the device to
the network, or after a power failure).The
water hardness indicator light begins to
flash.
e
f
-
features a
to the
2
system that
Water