Other Functions - Carson SKY EAGLE Betriebsanleitung

Other functions

GB
1. Power Indicator.
The indicator is consisted of three colours: red, yellow, and
green.
Green LED on means the battery voltage is enough to fly;
Green LED off and yellow LED on indicate the battery
voltage is not enough and stop flying;
Yellow LED off and red LED on show the power is in extreme
shortage, and please stop flying at once.
2. Elevator/ nick control trimming.
It controls and modifies your helicopter forward and
backward. Push up to fly forward, and pull down to fly
backward.
3. Rudder/ tail rotor control trimming.
The trim controls and modifies your helicopter leftward and
rightward. Move the trim left to fly leftward, and move right
to fly rightward.
4. Throttle/ pitch control trimming.
The throttle trim controls your helicopter to ascend and
descend. Push up the trimm to ascend, and pull down to
descend.
5. Aileron/ roll control trimming.
The aileron trim controls your helicopter leftward and
rightward. Push the trim left and fly left, and push the trim
rightward and fly right.
DIP Switches Identification
(only if required)
1. Elevator.
Reverse the direction of elevator servo.
2. Aileron.
Reverse the direction of aileron servo.
3. Throttle.
Reverse the throttle stick direction.
Note: ascertain the throttle stick to work in a correct way
before flight.
4. Rudder.
Reverse the rudder stick direction.
5-12. Not used.
12 CARSON Helikopter SKY EAGLE 50 070 7042
6. Power swltch.
Turn on or off the power of the transmitter. Push up the
switch to turn on the power, and push down to turn off.
7. Hook.
Connect to the neck strap.
8. Antenna.
Transmit the signals.
9. Charge Jack.
Charge the rechargeable battery pack at current 50 mA,
voltage < 12 V.
Notice: the charge jack is forbidden to use for non-
rechargeable battery pack.
Please observe the correct polarity.
10. Training jack.
Connect to computer with simulator cable.
11. Battery box.
Please note the polarities while inserting the batteries.
12. Battery box cover:
Protects the transmitter battery. Please open the box
according to the arrow direction when replace the battery.
The factory default settings:
CHANNEL
1
2
3
4
5-12
ON/OFF
ON
ON
OFF
OFF
NOT USED