Functions For Control Set - Carson bluster250se Bedienungsanleitung

b. Functions for Control Set
GB
1
2
3
5
7
9
11
13
15
17
19
1 Telescope antenna
2 LCD
1. To read the battery voltage
2. Shows which channel is on "reverse"
3. To show the flying time
4. To show the flying mode
5. To show the status of the key lock (unlocked/ locked)
3 Pitch full-range deflection
4 Pitch trim
5 Switch 1
This switch controls channel 5. This one controls the gyro.
Can also be used for a collapsable landing gear, a camera,
etc.
6 3D switch
Switches "Normal/ hover flight" or "3D mode"
7 Switch "MODEL" to choose the requested flight model
MODEL A: simulaton of flaps
MODEL V: additional function
MODEL H, C, C1: Freewheel in the mid position of the gas/
pitch joystick.
WARNING!
If the models H, C und C1 are choosed, you only can switch
to 3D mode, if the gas/ pitch joystick is in mid position!
8 LED (green) indicator for power
9 LED (red) indicator for low voltage
If the red LED flashes, immediately change the sender
batteries, at the latest when the LCD display extinguishes!
10 Right joystick (channel 2 and 1)
10 CARSON 3D Helicopter Bluster 250se 50 050 7028
4
6
25
8
10
12
14
16
18
11 Left joystick (channel 3 and 4 )
Both joysticks can be lengthened about 5 mm.
12 Trim channel 2
13 Trim channel 4
14 Trim channel 1
15 Trim channel 3
16 Ring for neck strap
17 Power on/ off switch
WARNING!
Switching on the sender with preselected MODEL H, C und
C1, the 3D switch has to be at "NOR"!
18 "LOCK" slide switch to lock the control dial and the
pushbutton "MODEL".
19 Reverse switch channel 1, 2, 3, 4, 6
Up: NOR (normal)
Down: REV (reverse)
20 Carry handle
21 Crystal (back of the transmitter)
22 Battery bay (back of the transmitter)
23 Socket for fly simulator (back of the transmitter)
24 Rechargeable socket (side)
25 Snap switch, dual rate channel 1, 2, 4
Reduction of the ways of function 1, 2 and 4 from 100%
(Pos. 0) to 70% (Pos. 1)
20
21
22
24
23