Receiver Identification - Carson SKY EAGLE Betriebsanleitung

d. Receiver Identification
1. Mixing ratio (Torque balance front/ rear rotors):
Only if the trimming of rudder/ tail rotor function is no longer
adequate may the torque of the front and rear main rotor be
balanced by means of this adjusting screw.
Clockwise adjustment increases the mixing ratio and
counterclockwise decreases the mixing ratio.
2. EXTENT (Servo extent adjustment):
EXTENT knob is used to set up the servo travel. Clockwise
adjustment increases the servo travel, and counterclockwise
adjustment decreases the servo travel.
Less servo movement for more sluggish flight
characteristics.
More servo movement for more agile flight characteristics.
3. Gyro sensivity adjustment (SENSITlVE):
If your helicopter remains unstable in the air despite
trimming of the tail rotor function, the gyro sensitivity may
be adjusted.
Adjust the sensitivity according to the flight performance.
Clockwise adjustment increases the sensitivity and
counterclockwise adjustment decreases the sensitivity.
4. AILE/ Roll servo connection:
Aileron, connect to the aileron servo.
5. ELEV/ Nick servo connection:
Elevator, connect to the elevator servo.
6. ESC signal wire:
Connect to ESC signal wire.
7. 2.4 GHz Status LED:
LED indicates the receiving status.
Rapid flashing means that the signal is being verified.
An illuminated LED means that the signal has been received,
and slow flashing means that the signal has been lost or has
not been received.
8. Connection for front motors
9. Connection for rear motors
10. Power cable.
Connect to the battery.
CARSON Helikopter SKY EAGLE 50 070 7042
➅ ➄ ➃
➉
GB
➆
➀
➁
➂
➇
➈
➅
13